User's Manual

544 Headset support
Enabling Bluetooth wireless technology
The following methods are available to enable Bluetooth wireless
technology on the IP Phone
• Manual configuration— is used to set the Bluetooth wireless
technology mode on the IP Phone on a phone-by-phone basis. If
manual configuration is used exclusively, a TFTP server is not required
to configure Bluetooth wireless technology. For further information
about manual configuration, see “Manual configuration” (page 544).
Use Procedure 144 “Configure the Bluetooth wireless technology
administration setting” (page 545) to configure the Bluetooth wireless
technology through the Local Tools > Network Configuration
submenu.
•
TFTP configuration—is used to initially set the Bluetooth wireless
technology mode then the TFTP Server can be removed. The IP
Phone now retains the value and uses the last value received if no new
value is received.
Use Procedure 145 “Enabling Bluetooth wireless technology on the
IP Phone 1140E” (page 545)to enable Bluetooth wireless technology
on the IP Phone 1140E using the TFTP configuration file (1140e.cfg)
retrieved during bootup.
If Bluetooth wireless technology is enabled on your phone, and
password-protection for the Local Tools menu has been enabled, you
can still double-press the Headset key to access the 3. Bluetooth
Setup menu.
If you enable Bluetooth wireless technology and password protection for
the Local Tools menu on your IP Phone you can double-press the Headset
key to access the Bluetooth Setup menu.
Manual configuration
You can enable or disable Bluetooth wireless technology through the
Network Configuration menu. The Enable Bluetooth option provides
administration control over Bluetooth wireless technology. The following
values are available
• Auto—(default) Bluetooth wireless technology setting received through
TFTP configuration
• Yes—Bluetooth wireless technology is enabled on the IP Phone
• No—Bluetooth wireless technology is disabled on the IP Phone
When the IP Phone firmware is upgraded or when the IP Phone is
received from the manufacturer with the latest firmware, the default power
up setting is Auto. When the setting is Auto, the setting received from the
TFTP Device Config file controls whether Bluetooth wireless technology
is enabled.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.07
5 February 2009
Copyright © 2003-2009 Nortel Networks
.