User's Manual

546 Headset support

ATTENTION

If the TFTP server is configured and running, skip to step 5 to configure the IP

Phone 1140E with the TFTP Server IP address.

Step Action

1 Add the [DEVICE_CONFIG] section to the 1140e.cfg file.

2 Create the device configuration file. This file must have the same

name as that specified for the FILENAME parameter in the

[DEVICE_CONFIG] section of the 1140e.cfg file. See Figure 82

"Sample of the 1140eDEV.cfg file" (page 546).

Figure 82

Sample of the 1140eDEV.cfg file

3 The device configuration file (1140eDEV.cfg) enables Bluetooth

wireless technology if ENABLE_BT 1 is present. If ENABLE_BT

0 is present, Bluetooth wireless technology is disabled. Figure 83

"Sample of the 1140E.cfg file" (page 546) shows an example of

the 1140e.cfg file with the FW and the ENABLE_BT line.

It is also possible to use the 1140e.cfg file with only the

[DEVICE_CONFIG] section for the control of Bluetooth wireless

technology. Figure 84 "Sample of the DEVICE_CONFIG file

with only the [DEVICE_CONFIG] section" (page 547) shows an

example of the 1140e.cfg file with only the [DEVICE_CONFIG]

section.

If only the [DEVICE_CONFIG] version is used, you must add the

[FW] section before the BootC FW recovery is used. Otherwise,

the BootC FW download fails and the IP Phone reverts to the

BootC TPS download screen.

Figure 83

Sample of the 1140E.cfg file

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 02.07

5 February 2009