User's Manual

Introduction 547
Figure 84
Sample of the DEVICE_CONFIG file with only the [DEVICE_CONFI
G] section
4 Start the TFTP Server. The TFTP Server must be running on
the network when the IP Phone 1140E powers up to retrieve the
Bluetooth wireless technology administrative control. After you
put the 1140e.cfg and the device config file in the TFTP Server
directory, ensure the TFTP Server is running then reboot the IP
Phone 1140E. For information about TFTP Server configuration,
see “TFTP Server” (page 557).
Once the IP Phone 1140E retrieves the setting when the IP
Phone 1140E restarts, it is saved in persistent memory. If the
Enable BT setting is set to Auto, then the received value is
acted on and Bluetooth wireless technology is either enabled or
disabled on the IP Phone 1140E. If the Device Config file with
the Enable BT setting is not received for any reason and the
Enable Bluetooth mode is set to Auto, then the phone uses the
last value received (retrieved from persistent memory).
If administrative control is not retrieved, the previously received
value is used. If no value has ever been retrieved, then
Bluetooth wireless technology is disabled by default.
If the IP Phone 1140E successfully retrieves the administrative
control and enables Bluetooth wireless technology, 3.
Bluetooth
Setup appears in the Preferences menu.
5 Configure the IP Phone 1140E with a TFTP Server IP address
so the IP Phone can access the TFTP Server.
6 Press the Services key twice.
7 Press 3 on the dialpad to access the Network Configuration
menu or use the Up/Down navigation keys to scroll and highlight
the Network Configuration option. Press Enter.
8 Enter the TFTP IP address in the TFTP IP field.
9 Press the Apply&Reset soft key.
--End--
Table 83 "1140e.cfg field name definitions" (page 548) lists the 1140e.cfg
field names and definitions.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.07
5 February 2009
Copyright © 2003-2009 Nortel Networks
.