User's Manual

548 Headset support
Table 83
1140e.cfg field name definitions
Field name Field value Definition
[FW] Section header for firmware download
information
DOWNLOAD_MODE AUTO Recommended setting. FW is downloaded
when the IP Phone FW version is older than the
value in the 1140e.cfg file VERSION field.
VERSION 0625Cxx FW version
FILENAME 0625Cxx.bin image file name, must match the file name of
the FW file
PROTOCOL TFTP Download protocol must be TFTP
SERVER_IP
xxx.xxx.xxx.xxx
IP address of the TFTP server that downloads
the FILENAME file.
SECURITY_MODE
0
For future use.
Possible reasons Bluetooth wireless technology remains disabled on
the IP Phone after bootup The following are possible reasons Bluetooth
wireless technology remains disabled on the IP Phone 1140E after bootup
• The TFTP Server is down or is no longer present on the network.
•
Network failure.
•
The DEVICE_CONFIG section is missing from the 1140e.cfg file or
is present but the specified device config file cannot be accessed, or
it can be accessed but the ENABLE_BT line is either missing, or is
present but the value of 1 is missing.
Create the DEVICE CONFIG section and file The file pointed to by the
[DEVICE CONFIG] section contains the parameter, ENABLE_BT. The
parameter value is set to 1, which enables Bluetooth wireless technology.
The [DEVICE_CONFIG] section can point to a single file that enables or
disables the Bluetooth wireless technology on all phones, or it can point
to a device configuration file for specific phones using a wildcard file
name to enable the Bluetooth wireless technology for select phones. The
configuration files for the specific phones use the IP Phone MAC address
as the file name with the .cfg file extension.
Table 84 "[DEVICE_CONFIG] field name definitions" (page 549) lists the
[DEVICE_CONFIG] section field names and definitions.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.07
5 February 2009
Copyright © 2003-2009 Nortel Networks
.