User's Manual

ManualsBrandsAvaya ManualsIP DeskphonesAvaya Communication Server 1000 IP Phones Fundamentals

561

562

563

564

565

566

567

568

569

570

566 TFTP Server

Table 87 "Fields in the TFTP configuration file for the Expansion Module"

(page 566) describes the fields in the configuration file on the TFTP

Server. The section [GEM FW] indicates the firmware is for the Expansion

Module. Set the download mode to AUTO or FORCED. It is recommended

that you set DOWNLOAD_MODE to AUTO.

Table 87

Fields in the TFTP configuration file for the Expansion Module

Field Name Field Value Descriptions

[GEM FW] Section header for the Expansion Module

firmware download information.

AUTO Recommended setting. The application looks

at the version and downloads the FW if it is a

newer version than the one on the phone.

DOWNLOAD_MODE

FORCED The version of firmware is ignored. The

firmware is always downloaded.

VERSION The version string compared to the one on the

phone.

FILENAME Image file name. This name must match the file

name of the actual IP Phone FW file.

PROTOCOL TFTP Download protocol. This must be TFTP.

SERVER_IP

xxx.xxx.xxx.xxx

IP Address of the TFTP server in decimal.

SECURITY_MODE

For future use.

After the IP Phone downloads the firmware from the TFTP Server, the

firmware is upgraded for any attached Expansion Modules, one at a time.

The Expansion Module verifies that the firmware was downloaded and

saved successfully before the IP Phone initiates the firmware download to

the next attached Expansion Module. If any errors occur, which prevent

the firmware from downloading or saving properly, the Expansion Module

reverts to the factory installed firmware. This version of firmware is always

available in case the downloaded firmware is unusable.

Downloading and conﬁguring fonts

The font files are downloaded as needed using the same TFTP Server

configuration file method as IP Phone 2007, IP Phone 1120E, IP Phone

1140E, and IP Phone 1150E.

The IP Phone downloads the required files specified in the configuration

file, as necessary. Table 88 "Fields in the TFTP configuration file for

downloadable fonts" (page 567) describes the fields in the configuration

file on the TFTP Server for downloadable fonts. The section [FONTxx]

indicates the font file. Set the download mode to AUTO or FORCED.

Nortel recommends that you set DOWNLOAD_MODE to AUTO.

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 02.07

5 February 2009