User's Manual

58 Nortel IP Phone 2002

This section contains the following procedures:

•

Procedure 10 “Configuring the IP Phone 2002” (page 70).

• Procedure 11 “Installing the IP Phone 2002 using manual

configuration” (page 73).

• Procedure 12 “Installing an IP Phone 2002 using DHCP” (page 80).

• Procedure 13 “Enabling Full Duplex mode” (page 87).

• Procedure 14 “Checking Ethernet Statistics” (page 88).

•

Procedure 15 “Changing the TN of an existing IP Phone 2002” (page

89).

• Procedure 16 “Replacing an IP Phone 2002” (page 90).

• Procedure 17 “Removing an IP Phone 2002 from service” (page 91).

After you install and configure an IP Phone, if power to the phone is

interrupted, you need not re-enter the IP parameters, node number,

Terminal Number (TN), or reacquisition of firmware.

Description

The IP Phone 2002 uses the customer IP data network to communicate

with the Communication Server 1000 (CS 1000). The IP Phone 2002

translates voice into data packets for transport using Internet Protocol.

Use a Dynamic Host Configuration Protocol (DHCP) server to provide

information that you can use for the IP Phone 2002 network and CS 1000

connections.

Figure 5 "IP Phone 2002" (page 59) shows the IP Phone 2002.

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 02.07

5 February 2009