User's Manual

Installation and configuration 69
For more information, and for information about previous versions of the IP
Phone, contact Nortel.
Installation and configuration
The following sections provide a step-by-step guide to install and configure
the IP Phone 2002:
•
“Before you begin” (page 69)
•
“First-time installation” (page 69)
•
“Configuring the IP Phone 2002” (page 70)
• “Startup sequence” (page 72)
• “Installing the IP Phone 2002” (page 73)
Before you begin
Before installing the IP Phone 2002, complete the following pre-installation
checklist:
•
Ensure one IP Phone 2002 boxed package exists for each IP Phone
2002 you install. For a list of IP Phone 2002 package components, see
Table 8 "Package components" (page 67).
• Ensure one Software License exists for each IP Phone 2002 you
install.
•
Ensure the host Call Server is equipped with a Signaling Server that
runs the Line Terminal Proxy Server (LTPS) application.
•
If an AC power adapter is required, ensure you use the correct AC
power transformer. The voltage rating of the transformer must match
the wall outlet voltage. See Table 9 "IP Phone 2002 components list"
(page 67).
•
Ensure the latest IP Phone firmware is deployed to the IP
telephony node. For more information, see IP Line Fundamentals
(NN43100-500).
First-time installation
You must first install an IP telephony node with the Communication Server.
For information about installing an IP telephony node, see Signaling Server
Installation and Commissioning (NN43001-312) or IP Line Fundamentals
(NN43100-500).
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.07
5 February 2009
Copyright © 2003-2009 Nortel Networks
.