User's Manual

Installation and configuration 71

2002 Ethernet network interface connections" (page 71)) and

the other end into the computer.

The LAN Ethernet port supports Auto-Media Dependent Interface

Crossover (MDIX). Auto-MDIX is supported only when the

Ethernet port is configured for autonegotiation. The PC Port

does not support Auto-MDIX.

CAUTION

Damage to Equipment

Do not plug any device into your IP Phone 2002

Ethernet port other than an IEEE 802.3 Ethernet

network connection. The IP Phone 2002 does not

support multiple devices connected through the PC

Ethernet port.

Figure 7

IP Phone 2002 Ethernet network interface connections

5 Connect the AC power adapter (optional). Leave the AC adapter

unplugged from the power outlet, connect the adapter to the AC

adapter jack in the bottom of the phone. Form a small bend in

the cable and then thread the adapter cord through the channels

in the stand.

6 Secure the IP Phone footstand to the base of the IP Phone. Use

the angle adjustment grip on the top back of the IP Phone to

adjust the position.

7 Power the IP Phone 2002 using either the Power over Ethernet

or an AC power transformer (local power). If you are using local

power, plug the AC power transformer into the nearest power

outlet. Make sure you use the correct AC power transformer is

used. The voltage rating of the transformer must match the wall

outlet voltage. See Table 9 "IP Phone 2002 components list"

(page 67).

The IP Phone 2002 supports both AC power and Power over

LAN options, including IEEE 802.3af Power Classification 2.

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 02.07

5 February 2009