User's Manual

Installation and configuration 73
Installing the IP Phone 2002
To install the IP Phone 2002 using manual configuration, use Procedure
11 “Installing the IP Phone 2002 using manual configuration” (page 73).To
install the IP Phone 2002 using DHCP, see Procedure 12 “Installing an IP
Phone 2002 using DHCP” (page 80).
ATTENTION
Timing information
There are only four seconds between plugging in the IP Phone 2002 power
transformer and the appearance of the Nortel logo in the middle of the display.
When you see the logo, you have one second to respond by pressing the four
soft keys at the bottom of the display in sequence from left to right, one at a
time. If you miss the one-second response time, the IP Phone 2002 attempts to
locate the connect server. You can begin the power-up sequence again, or you
can double-press the Services key to open the network diagnostic utilities to
access the IP Phone settings. See “IP Phone diagnostic utilities” (page 493).
To edit network configuration, the following soft keys are available:
• OK—accept current settings and proceed to the next configuration
option. If all configuration options are presented, the configuration is
saved and the IP Phone reboots with the saved changes.
•
BkSpace—erase a configuration entry to change it
•
Clear—clear an entire configuration entry
•
Cancel—cancels network configuration. The IP Phone reboots without
saving changes.
ATTENTION
When you install the IP Phone for the first time the first prompt that appears is
the DCHP? [0-N, 1-Y]. Not all of the listed screen prompts appear on the phone
display during the first time installation of the phone.
Procedure 11
Installing the IP Phone 2002 using manual configuration
Step Action
1 Power your IP Phone.
2 When the Nortel logo appears in the middle of the display,
immediately press the four soft keys at the bottom of the display
in sequence from left to right.
3 At the prompt EAP Enable?, enter 1-Yes (1 for Yes) if the
network infrastructure supports 802.1x port-based network
access control.
4 Enter DeviceID and Password.
If you select No, you are not prompted to enter Device ID and
Password.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.07
5 February 2009
Copyright © 2003-2009 Nortel Networks
.