User's Manual

80 Nortel IP Phone 2002

ATTENTION

Timing information

There are only 4 seconds between plugging in the IP Phone 2002 power

transformer and the appearance of the Nortel logo in the middle of the display.

When you see the logo, you have 1 second to respond by pressing the four soft

keys at the bottom of the display in sequence from left to right, one at a time. If

you miss the 1-second response time, the IP Phone 2002 attempts to locate

the connect server. You can begin the power-up sequence again, or you can

double-press the Services key to open the network diagnostic utilities to access

the IP Phone settings. See “IP Phone diagnostic utilities” (page 493).

To edit network configuration, the following soft keys are available:

•

OK—accept current settings and proceed to the next configuration

option. If all configuration options are presented, the configuration is

saved and the IP Phone reboots with the saved changes.

• BkSpace—erase a configuration entry to change it

•

Clear—clear an entire configuration entry

• Cancel—cancels network configuration. The IP Phone reboots without

saving changes.

ATTENTION

When you install the IP Phone for the first time the first prompt that appears is

the DCHP? [0-N, 1-Y]. Not all of the listed screen prompts appear on the phone

display during the first time installation of the phone.

Procedure 12

Installing an IP Phone 2002 using DHCP

Step Action

1 Power your IP Phone.

2 When the Nortel logo appears in the middle of the display,

immediately press the four soft keys at the bottom of the display

in sequence from left to right.

3 At the prompt EAP Enable?, enter 1-Yes (1 for Yes) if the

network infrastructure supports 802.1x port-based network

access control.

4 Enter DeviceID and Password.

If you select No, you are not prompted to enter Device ID and

Password.

For more information about EAP, see “802.1x Port-based

network access control” (page 479).

5 At the prompt, LLDP Enable?, enter 1-Y (1 for Yes, default).

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 02.07

5 February 2009