User's Manual
90 Nortel IP Phone 2002
a Disable the password.
b Set the password as non-NULL.
3 Press OK when the node number displays.
If Then
the node password is enabled
and is not NULL
a password screen displays. Go
to Step 4.
the node password is disabled a TN screen displays. Go to Step
5.
4 Enter the password at the password screen and press OK.
A TN screen displays.
To obtain the password, enter the nodePwdShow command in
Element Manager. For further information, see
Element Manager
System Reference—Administration (NN43001-632).
5 Select the Clear soft key to clear the existing TN.
6 Enter the new TN.
--End--
Replacing an IP Phone 2002
ATTENTION
Two IP Phones cannot share the same TN. You must remove the IP Phone
2002 that currently uses the TN.
Procedure 16
Replacing an IP Phone 2002
Step Action
1 Obtain the node and TN information of the phone you want to
replace.
2 Disconnect the IP Phone 2002 that you want to replace.
3 Follow Procedure 10 “Configuring the IP Phone 2002” (page
70) and Procedure 11 “Installing the IP Phone 2002 using
manual configuration” (page 73) or Procedure 12 “Installing an IP
Phone 2002 using DHCP” (page 80) to install and configure the
IP Phone 2002.
4 Enter the same TN and Node Number as the IP Phone 2002 you
replaced. The Call Server associates the new IP Phone 2002
with the existing TN.
--End--
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.07
5 February 2009
Copyright © 2003-2009 Nortel Networks
.