User's Manual

94 Nortel IP Phone 2004

• Procedure 20 “Installing an IP Phone 2004 using DHCP” (page 116).

• Procedure 21 “Enabling Full Duplex mode” (page 124).

• Procedure 22 “Checking Ethernet Statistics” (page 125).

•

Procedure 23 “Changing the TN of an existing IP Phone 2004” (page

126).

• Procedure 24 “Replacing an IP Phone 2004” (page 127).

• Procedure 25 “Removing an IP Phone 2004 from service” (page 128).

After you install and configure an IP Phone, if power to the phone is

interrupted, you need not re-enter the IP parameters, node number,

Terminal Number (TN), or reacquisition of firmware.

Description

The IP Phone 2004 uses the customer IP data network to communicate

with the Communication Server 1000 (CS 1000). The IP Phone 2004

translates voice into data packets for transport using Internet Protocol.

Use a Dynamic Host Configuration Protocol (DHCP) server to provide

information that you can use for the IP Phone 2004 network and CS 1000

connections.

Figure 8 "IP Phone 2004" (page 94) shows the IP Phone 2004.

Figure 8

IP Phone 2004

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 02.07

5 February 2009