User's Manual

104 Nortel IP Phone 2007

• Procedure 26 “Replacing an IP Phone 2007” (page 120).

• Procedure 27 “Removing an IP Phone 2007 from service” (page 121).

If power to the phone is interrupted after you install and configure an IP

phone, you are not required to reenter the IP Parameters, Node Numbers,

or Terminal Number (TN). There is also no need to again acquire the

firmware.

Description

The IP Phone 2007 uses the customer IP data network to communicate

with the Communication Server 1000 (CS 1000). The IP Phone 2007

translates voice into data packets for transport using Internet Protocol.

Use a Dynamic Host Configuration Protocol (DHCP) server to provide

information that you can use for the IP Phone 2007 network and CS 1000

connections.

Figure 18 "IP Phone 2007" (page 104) shows the IP Phone 2007.

Figure 18

IP Phone 2007

Components and functions

This section describes the following components and functions of the IP

Phone 2007:

• “Keys and functions” (page 105)

• “Services menu” (page 106)

• “Local Tools menu” (page 107)

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.06 30 April 2010