User's Manual

118 Nortel IP Phone 2007
• Ensure the host Call Server is equipped with a Signaling Server that
runs the Line TPS application.
• If you are not using Power over Ethernet (PoE) you must use the
global power supply or your phone fails to operate. See Table 26 "IP
Phone 2007 component list" (page 116).
• Ensure the latest IP Phone firmware is deployed to the IP telephony
node. For more information, see Signaling Server IP Line Applications
Fundamentals (NN43001-125).
First-time installation
You must first install an IP telephony node with the Communication Server.
For information about installing an IP telephony node, see Signaling Server
IP Line Applications Fundamentals (NN43001-125).
CAUTION
Damage to Equipment
Do not plug your IP Phone 2007 into an ISDN connection.
Severe damage can result.
Configuring the IP Phone 2007
Use Procedure 24 “Configuring the IP Phone 2007” (page 118) to
configure the IP Phone 2007.
Procedure 24
Configuring the IP Phone 2007
Step Action
1 Configure a virtual loop on the system using LD 97.
For more information about configuring a virtual loop, see
Signaling Server IP Line Applications Fundamentals (NN430
01-125) and Software Input Output Reference-Administration
(NN43001-611).
2 Configure the IP Phone 2007 on the system using LD 11. At the
prompt, enter the following:
REQ:new
TYPE:2007
To configure the IP Phone 2007 using LD 11, see Software Input
Output Reference-Administration (NN43001-611).
3 Configure the IP Phone 2007 in Element Manager. IP Phones
are configured using the Phones section in the Element
Manager navigation tree. For more information about configuring
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.06 30 April 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
.