User's Manual

120 Nortel IP Phone 2007
During the reboot sequence of a previously configured IP
Phone, the IP Phone 2007 displays the existing node number
for approximately five seconds.
2 If the node password is enabled and NULL, choose one of the
following:
a Disable the password.
b Set the password as non-NULL.
3 Press OK when the node number displays.
If Then
the node password is enabled
and is not NULL
a password screen displays. Go
to Step 4.
the node password is disabled a TN screen displays. Go to Step
5.
4 Enter the password at the password screen, and press OK.
A TN screen displays.
To obtain the password, enter the nodePwdShow command in
Element Manager. For further information, see Element Manager
System Reference - Administration (NN43001-632).
5 Select the Clear soft key to clear the existing TN.
6 Enter the new TN.
--End--
Replacing an IP Phone 2007
ATTENTION
Two IP Phones cannot share the same TN. You must remove the IP Phone
2007 that currently uses the TN.
Procedure 26
Replacing an IP Phone 2007
Step Action
1 Obtain the node and TN information of the phone you want to
replace.
2 Disconnect the IP Phone 2007 that you want to replace.
3 Follow “Configuring the IP Phone 2007” (page 118) to install
the IP Phone 2007. To configure the IP Phone, see “Manual
provisioning of IP Phones 2007 and 1100 Series” (page 541).
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.06 30 April 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
.