User's Manual

Removing an IP Phone 1210 from service 137

7 Click OK to save and accept changes.

--End--

Replacing an IP Phone 1210

ATTENTION

Two IP Phones cannot share the same TN. You must remove the IP Phone

1210 that currently uses the TN.

Procedure 31

Replacing an IP Phone 1210

Step Action

1 Obtain the node and TN information of the phone you want to

replace.

2 Disconnect the IP Phone 1210 that you want to replace.

3 Follow “Configuring the IP Phone 1210” (page 132) to install

the IP Phone 1210. To configure the IP Phone, see “Manual

provisioning of IP Phones 1110 and 1200 Series” (page 533).

4 Enter the same TN and node number as the IP Phone 1210 you

replaced. The system associates the new IP Phone 1210 with

the existing TN.

--End--

Removing an IP Phone 1210 from service

Procedure 32

Removing an IP Phone 1210 from service

Step Action

1 Disconnect the IP Phone 1210 from the network or turn off the

power.

If the IP Phone 1210 was automatically configured, the DHCP

lease expires and the IP address returns to the available pool.

2 In LD 11, enter the following:

REQ: OUT

TYPE: 1210

TN: LLL S CC UU

--End--

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.06 30 April 2010