User's Manual

Installation and configuration 149
Installation and configuration
The following sections provide a step-by-step guide to install and configure
the IP Phone 1220:
• “Before you begin” (page 149)
• “First-time installation” (page 149)
• “Configuring the IP Phone 1220” (page 150)
•
“Connecting the components” (page 150)
• “Startup sequence” (page 153)
Before you begin
Before installing the IP Phone 1220, complete the following pre-installation
checklist:
•
Ensure one IP Phone 1220 boxed package exists for each IP Phone
1220 you install. For a list of IP Phone 1220 package components, see
Table 35 "Package components" (page 148).
• Ensure one software license exists for each IP Phone 1220 you install.
•
Ensure the host call server is equipped with a Signaling Server that
runs the Line Terminal Proxy Server (LTPS) application.
•
If a global power supply is required, ensure you use the approved
Nortel global power supply (model number NTYS17xxE6).
•
Ensure the latest IP Phone firmware is deployed to the IP telephony
node. For more information, see Signaling Server IP Line Applications
Fundamentals (NN43001-125).
CAUTION
Ensure that the protective rubber cap on the Accessory
Expansion Module (AEM) port is in place when the port is not
in use. An improper connector can cause damage to the IP
Phone.
First-time installation
You must first install an IP telephony node with the Communication Server.
For information about installing an IP telephony node, see Signaling Server
IP Line Applications Fundamentals (NN43001-125).
CAUTION
Do not plug your IP Phone 1220 into an ISDN connection.
Severe damage can result.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.06 30 April 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
.