User's Manual

Installation and configuration 151

Figure 27 "IP Phone 1220 connections" (page 151) shows the IP

Phone 1220 connections.

Figure 27

IP Phone 1220 connections

a Align the bottom tabs on the foot stand with the position 1

slots or the position 2 slots on the back of your IP Phone. In

position 1 the IP Phone sits at a 25-degree angle. In position

2 the IP Phone sits at a 55-degree angle.

b Press the footstand into the slots until it snaps into place.

2 Connect the handset:

a Plug the end of the handset cord with the short straight

section into the handset.

b Plug the other end of the handset cord with the long straight

section into the handset jack marked with the handset symbol

on the back of the IP Phone.

c Thread the cord through the channel in the footstand

(if installed) so that it exits on the side of the foot stand

(optional).

3 Connect the headset (optional):

a Plug the headset cord into the headset jack on the back of

the IP Phone marked with the headset symbol.

b Thread the cord through the channel in the side of the foot

stand.

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.06 30 April 2010