User's Manual

172 Nortel IP Phone 1230
Step Action
1 Repower the IP Phone 1230.
During the reboot sequence of a previously-configured IP
Phone, the IP Phone 1230 displays the existing node number
for approximately 5 seconds.
2 If you configure the node password to NULL, choose one of the
following:
a Disable the password.
b Set the password as nonNULL.
3 Press OK when the node number displays.
If Then
you configure the node password
to NULL
a password screen displays. Go
to Step 4.
the node password is disabled a TN screen displays. Go to Step
5.
4 Enter the password at the password screen and press OK.
A TN screen displays.
To obtain the password, enter the nodePwdShow command in
Element Manager. For more information, see Element Manager
System Reference - Administration (NN43001-632).
5 Select the Clear soft key to clear the existing TN.
6 Enter the new TN.
7 Click OK to save and accept changes.
--End--
Replacing an IP Phone 1230
ATTENTION
Two IP Phones cannot share the same TN. You must remove the IP Phone
1230 that currently uses the TN.
Procedure 41
Replacing an IP Phone 1230
Step Action
1 Obtain the node and TN information of the phone you want to
replace.
2 Disconnect the IP Phone 1230 that you want to replace.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.06 30 April 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
.