User's Manual

Configuration 181
Table 45
LD 11—Configure the IP Phones 1200 Series LCD Expansion Module (cont’d.)
Prompt Response Description
TYPE 1220/1230 For IP Phone 1220, IP Phone 1230
TN l s c u Where l = loop, s = shelf, c = card, u = unit.
Enter loop (virtual loop), shelf, card, and unit (terminal
number), where unit = 0 to 31.
KEM (0) - 4/<CR> Number of attached KEM (0). Up to four LCD Expansion
Modules are supported.
... ... ...
CLS KEM4 KEM4 CLS must be defined
KEY 0 - <see text>/<C
R>
Key number range expanded to support number of LCD
Expansion Modules specified by KEM prompt. The range
on the IP Phone is as follows:
KEM value:
0
1
2
3
4
KEY range:
0to31
32 to 43
44 to 55
56 to 67
68 to 79
PAGEOFST <Page> <KeyOff-
set> / <CR>
PAGEOFST is prompted if one or two LCD Expansion
Module are specified at the KEM prompt for the IP Phone
1230 and <CR> is entered at the KEY prompt. The
PAGEOFST is not supported on the IP Phone 1220.
Page number (0 to 3)
0 - first page on KEM 1
1 - second page on KEM 1
2 - first page on KEM 2
3 - second page on KEM 2
Key offset number (0 to 11).
After you enter the offset number, the KEY prompt is
prompted with the appropriate KEY value filled in.
<CR> ends the input.
KEY <key> <keys conf data>/
<CR>
<key> is the key number for the Page + Key Offset
entered at PAGEOFST. Enter the key configuration <CR>
or just <CR>.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.06 30 April 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
.