User's Manual

ManualsBrandsAvaya ManualsIP DeskphonesAvaya Communication Server 1000 IP Phones Fundamentals

181

182

183

184

185

186

187

188

189

190

182 Nortel IP Phones 1200 Series LCD Expansion Module

Table 45

LD 11—Configure the IP Phones 1200 Series LCD Expansion Module (cont’d.)

Prompt Response Description

KEMOFST <KEM> <Key-Off-

set> / <CR>

KEMOFST is prompted if three or four LCD Expansion

Modules are specified at the KEM prompt and <CR> is

entered for KEY prompt.

<KEM> - KEM number (1 to 4)

1 - for KEM 1 (32 to 43)

2 - for KEM 2 (44 to 55)

3 - for KEM 3 (56 to 67)

4 - for KEM 4 (68 to 79)

<Key Offset> - key offset number (0 to 11). After you

enter the offset number, the KEY prompt is prompted with

the appropriate KEY value filled in.

<CR> ends the input.

KEY <key> <keys conf data>/

<CR

<key> is the key number for the KEM + Key Offset

entered at KEYOFST. Enter the key configuration <CR>

or just <CR>.

Installation

The LCD Expansion Module mounts on the right side of the IP Phone. The

LCD Expansion Module snaps into the receptacle on the back of the IP

Phone using the desk-mount bracket and structural base plate supplied

with the LCD Expansion Module.

The LCD Expansion Module connects to the IP Phone using the Accessory

Expansion Module (AEM) port on the IP Phone.

Use Procedure 43 “Connecting the IP Phones 1200 Series LCD Expansion

Module to the IP Phone” (page 182) to connect the LCD Expansion

Module.

CAUTION

Damage to Equipment

To avoid damaging the equipment, remove the power (PoE

cable, or local power) from the IP Phone before connecting the

LCD Expansion Module.

Procedure 43

Connecting the IP Phones 1200 Series LCD Expansion Module to the IP

Phone

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.06 30 April 2010