User's Manual

ManualsBrandsAvaya ManualsIP DeskphonesAvaya Communication Server 1000 IP Phones Fundamentals

221

222

223

224

225

226

227

228

229

230

226 Nortel IP Softphone 2050

5 A DHCP server and DHCP relay agents, if required, must also

be installed, configured, and running.

--End--

First-time installation

During the first-time installation, the two IP address parameters

entered either manually or automatically, depending on the installation

configuration. They are as follows:

•

Static IP address assignment

• Partial DHCP

Installing the IP Softphone 2050 for the ﬁrst time

Use Procedure 57 “Configuring an IP Softphone 2050 ” (page 226) to

install an IP Softphone 2050 for the first time.

Procedure 57

Conﬁguring an IP Softphone 2050

Step Action

1 Install the Voice Gateway Media Card. For more information,

see Signaling Server IP Line Applications Fundamentals

(NN43001-125).

2 Configure a virtual loop on the Call Server, using LD 97.

For more information, see Software Input Output

Reference-Administration (NN43001-611).

3 Configure the IP Softphone 2050 using LD 11. At the prompt,

enter the following

REQ: new

TYPE: 2050PC

4 Install the USB Headset Adapter. If you are using the mobile

adapter, connect the headset to the adapter. If you are using the

desktop adapter, you must

a Connect the coiled lower cord to the headset cord with the

Quick Disconnect connector. Ensure the Quick Disconnect

connector is securely fastened.

b Connect the headset cord to the RJ9 jack on the adapter.

5 Connect the USB cable to the headset adapter and to one of the

USB jacks on the back of your PC or USB hub.

The first time the headset adapter is plugged in, a delay occurs

while Windows configures the device and locates the appropriate

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.06 30 April 2010