User's Manual

Installing or upgrading the IP Softphone 2050 233
1. Click Immediately uninstall the software from users and
computers.
2. Click OK.
Or
1. Click Allow users to continue to use the software, but
prevent new installations.
2. Click OK.
13 Close the Group Policy snap-in.
14 Click OK.
15 Exit the Active Directory Users and Computers snap-in.
--End--
Silent installation
Silent installations run without a user interface. Configure the values
of public properties, such as USERNAME, COMPANYNAME, and
INSTALLDIR at the command line.
Use the following methods to pass data to the installation:
• The /v argument is used to pass command line switches and values
of public properties.
•
The /q option is used to configure the user interface level in conjunction
with the following flags:
— q or qn creates no user interface
—
qb creates a basic user interface (progress bar)
• To run a setup.msi silently, enter msiexec/i setup.msi/qn at the
command line.
•
To run a setup.exe silently, enter setup.exe/s /v/qn at the command
line.
• To set installation properties run a command line, such as msiexec/i
Product.msi/qnINSTALLDIR=D:\ProductFolderUSERNAME="Valued
Customer".
• To repair or reinstall missing or corrupted files, install with the /f option,
in conjunction with the following flags:
— p reinstalls a file if it is missing
— o reinstalls a file if it is missing or if an older version of the file is
present on the user’s system
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.06 30 April 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
.