User's Manual

Installation and configuration 281
Installation and configuration
The following sections provide a step-by-step guide to install and configure
the IP Phone 1110
• “Before you begin” (page 281)
• “First-time installation” (page 281)
• “Configuring the IP Phone 1110” (page 281)
•
“Connecting the components” (page 282)
• “Startup sequence” (page 287)
Before you begin
Before installing the IP Phone 1110, complete the following pre-installation
checklist
•
Ensure one IP Phone 1110 boxed package exists for each IP Phone
1110 you install. For a list of IP Phone 1110 package components, see
Table 59 "Package components" (page 279).
• Ensure one Software License exists for each IP Phone 1110 you
install.
• Ensure the host Call Server is equipped with a Signaling Server that
runs the Line TPS application.
•
If a global power supply is required, ensure the approved Nortel global
power supply (model number NTYS17xxE6) is used. See Table 60 "IP
Phone 1110 components list" (page 280).
•
Ensure the latest IP Phone firmware is deployed to the IP telephony
node. For more information, see Signaling Server IP Line Applications
Fundamentals (NN43001-125).
First-time installation
You must first install an IP telephony node with the Communication Server.
For information about installing an IP telephony node, see Signaling Server
IP Line Applications Fundamentals (NN43001-125).
CAUTION
Do not plug your IP Phone 1110 into an ISDN connection.
Severe damage can result.
Configuring the IP Phone 1110
Use Procedure 76 “Configuring the IP Phone 1110” (page 282) to
configure the IP Phone 1110 for the first time.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.06 30 April 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
.