User's Manual

282 Nortel IP Phone 1110
Procedure 76
Configuring the IP Phone 1110
Step Action
1 Configure a virtual loop on the Call Server using LD 97.
For more information about configuring a virtual loop, see
Signaling Server IP Line Applications Fundamentals (NN430
01-125) and Software Input Output Reference-Administration
(NN43001-611).
2 Configure the IP Phone 1110 on the Call Server using LD 11. At
the prompt, enter the following
REQ:new
TYPE: 1110
For more information about configuring the IP Phone 1110 using
LD 11, see Software Input Output Reference-Administration
(NN43001-611).
3 Configure the IP Phone 1110 in Element Manager. IP Phones
are configured using the Phones section in the Element
Manager navigation tree. For more information about configuring
the IP Phone 1110 using Element Manager, see Element
Manager System Reference - Administration (NN43001-632).
--End--
Connecting the components
Use Procedure 77 “Connecting the components” (page 282) to connect
the components for the IP Phone.
CAUTION
The IP Phone 1110 is shipped with the stand and stand cover
locked in position. To avoid damaging the IP Phone, press the
wall-mount lever to release the stand and pull it away from the
base using the tilt lever.
Procedure 77
Connecting the components
Step Action
1 Press the wall-mount lever to release the stand and pull it away
from the base using the tilt lever. See Figure 42 "Release the IP
Phone 1110 from the stand" (page 283).
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.06 30 April 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
.