User's Manual

284 Nortel IP Phone 1110

phone. Form a small bend in the cable, and then thread the

global power supply cord through the channels in the stand.

WARNING

Use your IP Phone 1110 with the approved Nortel

global power supply (model number NTYS17xxE6).

The IP Phone 1110 supports both AC power and Power over

LAN options, including IEEE 802.3af Power Classification 2. To

use Power over Ethernet, where power is delivered over the

CAT5-e cable, the LAN must support Power over Ethernet, and a

global power supply is not required. To use local AC power, the

optional global power supply can be ordered separately.

Figure 44 "IP Phone 1110 connections" (page 284) shows the IP

Phone 1110 connections.

Figure 44

IP Phone 1110 connections

4 Install the handset. Connect the end of the handset cable with

the short straight section into the handset. Connect the end of

the handset cable with the long straight section to the back of the

phone, using the RJ-9 handset jack. Form a small bend in the

cable, and then thread the handset cord through the channels in

the stand so that it exits behind the handset on the right side, in

the channel exit in the stand base. See Figure 45 "Cable routing

tracks" (page 285).

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.06 30 April 2010