User's Manual

ManualsBrandsAvaya ManualsIP DeskphonesAvaya Communication Server 1000 IP Phones Fundamentals

281

282

283

284

285

286

287

288

289

290

286 Nortel IP Phone 1110

Complete steps 1 to 6, as needed, before wall-mounting the IP

Phone.

7 Wall-mount your phone (optional). Use Method A or Method B to

wall-mount the IP Phone. See Method A—using the mounting

holes on the bottom of the phone stand, or Method B—using the

traditional-style wall-mount box with a CAT5-e connector and

a 15 cm (6 inch) CAT5-e cord (not provided). See Figure 45

"Cable routing tracks" (page 285).

•

Method A: Press the wall-mount lever, and pull away from

the stand. Using the stand cover (see step 2), mark the

wall-mount holes by pressing the bottom of the stand cover

firmly against the wall in the location where you wish to install

the phone. Four small pins on the bottom of the stand cover

make the marks on the wall. Use the marks as a guideline to

install the wall-mount screws (not provided).

Install the screws so that they protrude 3 mm (1/8 inch) from

the wall, and then install the phone stand mounting holes

over the screw heads. You may need to remove the phone

from the wall to adjust the lower screws. When the lower

screws are snug, install the phone on the mounting screws,

and then tighten the top screws.

• Method B: Attach the 15 cm (6 inch) CAT5-e cable (not

provided), position the stand over the mounting rivets, and

slide the phone down the wall so that the rivets fit into the

slots on the stand.

8 Replace the stand cover. Ensure that all cables are neatly routed

and press the stand cover into place until you hear a click.

9 If you wall-mount the phone, put it in the wall-mount position by

holding the tilt lever and press the phone towards the base until

the phone is parallel with the base. Release the tilt lever and

continue to push the phone towards the base until you hear an

audible click. Ensure the phone is securely locked in to position.

10 Connect additional cables. Connect the Ethernet cable to the

LAN Ethernet connection. If you are using a global power supply,

plug the global power supply into an AC outlet.

--End--

When you complete the IP Phone connection, you must connect the phone

to the network. See “Dynamic Host Configuration Protocol” (page 424).

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.06 30 April 2010