User's Manual

288 Nortel IP Phone 1110
2 If the node password is enabled and NULL, choose one of the
following
a Disable the password.
b Set the password as non-NULL.
3 Press OK when the node number displays.
If Then
the node password is enabled
and is not NULL
a password screen displays. Go
to Step 4.
the node password is disabled a TN screen displays. Go to Step
5.
4 Enter the password at the password screen and press OK.
A TN screen displays.
To obtain the password, enter the nodePwdShow command in
Element Manager. For further information, see Element Manager
System Reference - Administration (NN43001-632).
5 Select the Clear soft key to clear the existing TN.
6 Enter the new TN.
--End--
Replacing an IP Phone 1110
ATTENTION
Two IP Phones cannot share the same TN. You must remove the IP Phone
1110 that currently uses the TN.
Procedure 79
Replacing an IP Phone 1110
Step Action
1 Obtain the node and TN information of the phone you want to
replace.
2 Disconnect the IP Phone 1110 that you want to replace.
3 Follow “Configuring the IP Phone 1110” (page 281) to install
the IP Phone 1110. To configure the IP Phone, see “Manual
provisioning of IP Phones 1110 and 1200 Series” (page 533).
4 Enter the same TN and Node Number as the IP Phone 1110 you
replaced. The Call Server associates the new IP Phone 1110
with the existing TN.
--End--
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.06 30 April 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
.