User's Manual

302 Nortel IP Phone 1120E
Before you begin
Before installing the IP Phone 1120E, complete the following
pre-installation checklist
• Ensure one IP Phone 1120E boxed package exists for each IP Phone
1120E you install. For a list of IP Phone 1120E package components,
see Table 65 "Package components" (page 300).
•
Ensure one Software License exists for each IP Phone 1120E you
install.
• Ensure the host Call Server is equipped with the a voice Gateway
Media Card and a Signaling Server with the Line TPS application.
•
If a global power supply is required, ensure the approved Nortel global
power supply (model number NTYS17xxE6) is used. See Table 66 "IP
Phone 1120E components list" (page 300).
• Ensure the latest IP Phone firmware is deployed to the IP telephony
node. For more information, see Signaling Server IP Line Applications
Fundamentals (NN43001-125).
First-time installation
You must first install an IP telephony node with the Communication Server.
For information about installing an IP telephony node, see Signaling Server
IP Line Applications Fundamentals (NN43001-125).
CAUTION
Damage to Equipment
Do not plug your IP Phone 1120E into an ISDN connection.
Severe damage can result. The IP Phone 1120E does not
support multiple devices connected through the PC Ethernet
port.
Configuring the IP Phone 1120E
Use Procedure 81 “Configuring the IP Phone 1120E” (page 302) to
configure the IP Phone 1120E for the first time.
Procedure 81
Configuring the IP Phone 1120E
Step Action
1 Configure a virtual loop on the Call Server using LD 97.
For more information about configuring a virtual loop, see
Signaling Server IP Line Applications Fundamentals (NN430
01-125) and Software Input Output Reference-Administration
(NN43001-611).
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.06 30 April 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
.