User's Manual

Installation and configuration 303

2 Configure the IP Phone 1120E on the Call Server using LD 11.

At the prompt, enter the following

REQ:new

TYPE: 1120

For more information about configuring the IP Phone 1120E usi

ng LD 11, see Software Input Output Reference-Administration

(NN43001-611).

3 Configure the IP Phone 1120E in Element Manager. IP Phones

are configured using the Phones section in the Element

Manager navigation tree. For more information about configuring

the IP Phone 1120E using Element Manager, see Element

Manager System Reference - Administration (NN43001-632).

--End--

Connecting the components

Use Procedure 82 “Connecting the components” (page 303) to connect

the components for the IP Phone.

CAUTION

The IP Phone 1120E is shipped with the stand locked in

position. To avoid damaging the IP Phone, press the wall-mount

lever located under the Handsfree key to release the stand and

pull it away from the phone.

Procedure 82

Connecting the components

Step Action

1 Press the wall-mount lever located under the Handsfree key to

release the stand and pull it away from the phone. See Figure 48

"Release the IP Phone 1120E from the stand" (page 304).

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.06 30 April 2010