User's Manual

308 Nortel IP Phone 1120E
The IP Phone is configured for automatic provisioning by default. For
more information about provisioning the IP Phone automatically, see
“Provisioning the IP Phones” (page 491).
You can manually configure all or some parameters. For information
about manually provisioning the IP Phone, see “Manual provisioning of IP
Phones 2007 and 1100 Series” (page 541).
TFTP firmware upgrade
When you enter Cfg TFTP = 1 (for yes), and enter an IP address, the IP
Phone searches for an upgrade file on the TFTP Server.
Users of CS 1000 Release 4.5, or later do not need to enter a TFTP IP
address.
For further information about TFTP firmware upgrade, see “TFTP Server”
(page 649).
Redeploying an IP Phone 1120E
You can redeploy an existing previously configured IP Phone 1120E on
the same Call Server. For example, the IP Phone 1120E can be assigned
to a new user (new TN) or to an existing user who moved to a new subnet
by changing the TN of the IP Phone 1120E. For further information, see
Converging the Data Network with VoIP Fundamentals (NN43001-260).
Procedure 83
Changing the TN of an existing IP Phone 1120E
Step Action
1 Repower the IP Phone 1120E.
During the reboot sequence of a previously configured IP Phone,
the IP Phone 1120E displays the existing node number for
approximately 5 seconds.
2 If the node password is enabled and NULL, choose one of the
following
a Disable the password.
b Set the password as non-NULL.
3 Press OK when the node number displays.
If Then
the node password is enabled
and is not NULL
a password screen displays. Go
to Step 4.
the node password is disabled a TN screen displays. Go to Step
5.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.06 30 April 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
.