User's Manual

Removing an IP Phone 1120E from service 309
4 Enter the password at the password screen and press OK.
A TN screen displays.
To obtain the password, enter the nodePwdShow command in
Element Manager. For further information, see
Element Manager
System Reference - Administration (NN43001-632).
5 Select the Clear soft key to clear the existing TN.
6 Enter the new TN.
--End--
Replacing an IP Phone 1120E
ATTENTION
Two IP Phones cannot share the same TN. You must remove the IP Phone
1120E that currently uses the TN.
Procedure 84
Replacing an IP Phone 1120E
Step Action
1 Obtain the node and TN information of the phone you want to
replace.
2 Disconnect the IP Phone 1120E that you want to replace.
3 Follow “Configuring the IP Phone 1120E” (page 302) to install
the IP Phone 1120E. To configure the IP Phone, see “Manual
provisioning of IP Phones 2007 and 1100 Series” (page 541).
4 Enter the same TN and Node Number as the IP Phone 1120E
you replaced. The Call Server associates the new IP Phone
1120E with the existing TN.
--End--
Removing an IP Phone 1120E from service
Procedure 85
Removing an IP Phone 1120E from service
Step Action
1 Disconnect the IP Phone 1120E from the network or turn off the
power.
The service to the PC is disconnected as well if the PC connects
to the IP Phone 1120E.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.06 30 April 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
.