User's Manual

322 Nortel IP Phone 1140E
Installation and configuration
The following sections provide a step-by-step guide to install and configure
the IP Phone 1140E
• “Before you begin” (page 322)
• “First-time installation” (page 322)
• “Configuring the IP Phone 1140E” (page 322)
•
“Connecting the components” (page 323)
• “Startup sequence” (page 328)
Before you begin
Before installing the IP Phone 1140E, complete the following
pre-installation checklist
•
Ensure one IP Phone 1140E boxed package exists for each IP Phone
1140E you install. For a list of IP Phone 1140E package components,
see Table 71 "Package components" (page 320).
• Ensure one Software License exists for each IP Phone 1140E you
install.
• Ensure the host Call Server is equipped with a Voice Gateway Media
Card and a Signaling Server with the Line TPS application.
•
If a global power supply is required, ensure the approved Nortel global
power supply (model number NTYS17xxE6) is used. See Table 72 "IP
Phone 1140E component list" (page 321).
•
Ensure the latest IP Phone firmware is deployed to the IP telephony
node. For more information, see Signaling Server IP Line Applications
Fundamentals (NN43001-125).
First-time installation
You must first install an IP telephony node with the Communication Server.
For information about installing an IP telephony node, see Signaling Server
IP Line Applications Fundamentals (NN43001-125).
CAUTION
Damage to Equipment
Do not plug your IP Phone 1140E into an ISDN connection.
Severe damage can result.
Configuring the IP Phone 1140E
Use Procedure 86 “Configuring the IP Phone 1140E” (page 323) to
configure the IP Phone 1140E.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.06 30 April 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
.