User's Manual

Installation and configuration 323
Procedure 86
Configuring the IP Phone 1140E
Step Action
1 Configure a virtual loop on the Call Server using LD 97.
For more information about configuring a virtual loop, see
Signaling Server IP Line Applications Fundamentals (NN430
01-125) and Software Input Output Reference-Administration
(NN43001-611).
2 Configure the IP Phone 1140E on the Call Server using LD 11.
At the prompt, enter the following
REQ: new
TYPE: 1140
For more information about configuring the IP Phone 1140E usi
ng LD 11, see Software Input Output Reference-Administration
(NN43001-611).
3 Configure the IP Phone 1140E in Element Manager. IP Phones
are configured using the Phones section in the Element
Manager navigation tree. For more information about configuring
the IP Phone 1140E using Element Manager, see Element
Manager System Reference - Administration (NN43001-632).
--End--
Connecting the components
Use Procedure 87 “Connecting the components” (page 323) to connect
the components for the IP Phone.
CAUTION
The IP Phone 1140E is shipped with the stand locked in
position. To avoid damaging the IP Phone, press the wall-mount
lever located under the Handsfree key to release the stand and
pull it away from the phone.
Procedure 87
Connecting the components
Step Action
1 Press the wall-mount lever located under the Handsfree key to
release the stand and pull it away from the phone. See Figure 54
"Release the IP Phone 1140E from the stand" (page 324).
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.06 30 April 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
.