User's Manual

326 Nortel IP Phone 1140E

Figure 57

Cable routing tracks

5 Install the headset (optional). If you are installing a headset,

plug the connector into the RJ-9 headset jack on the back of the

phone, and thread the headset cord along with the handset cord

through the channels in the stand, so that the headset cord exits

the channel marked with the headset symbol. See Figure 57

"Cable routing tracks" (page 326).

6 Install the Ethernet cable. Connect one end of the supplied

Ethernet cable to the back of your phone using the CAT5-e

connector (LAN Ethernet port), and thread the network cable

through the channel.

7 If you are connecting your PC through the phone, a second

CAT5-e cable is required. Only one cable is included with the IP

Phone 1140E package. Install the Ethernet cable connecting the

PC to the phone (optional). Connect one end of the PC Ethernet

cable to your phone using the CAT5-e (PC Ethernet port), and

thread it through the channel marked with the symbol. Connect

the other end to the LAN connector on the back of your PC.

The LAN Ethernet port supports Auto-Media Dependent Interface

Crossover (MDIX). Auto-MDIX is supported only when the

Ethernet port is configured for autonegotiation. The PC Port

does not support Auto-MDIX.

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.06 30 April 2010