User's Manual

328 Nortel IP Phone 1140E
When you complete the IP Phone connection, you must connect the phone
to the network. See “Dynamic Host Configuration Protocol” (page 424).
Startup sequence
When an IP Phone 1140E connects to the network, it must perform a
startup sequence. The elements of the startup sequence include
•
obtaining network access (if supported by the network infrastructure)
•
obtaining VLAN ID (if supported by the network infrastructure)
• obtaining the IP parameters
• obtaining the provisioning parameters
•
connecting to the Call Server
The IP Phone is configured for automatic provisioning by default. For
more information about provisioning the IP Phone automatically, see
“Provisioning the IP Phones” (page 491).
You can manually configure all or some parameters. For information
about manually provisioning the IP Phone, see “Manual provisioning of IP
Phones 2007 and 1100 Series” (page 541).
TFTP firmware upgrade
When you enter Cfg TFTP = 1 (for yes), and enter an IP address, the IP
Phone searches for an upgrade file on the TFTP Server.
Users of CS 1000 Release 4.5, or later do not need to enter a TFTP IP
address.
For further information about TFTP firmware upgrade, see “TFTP Server”
(page 649).
Bluetooth
®
wireless technology
The IP Phone 1140E supports Bluetooth
®
wireless technology. For
information about configuring Bluetooth
®
wireless technology on the IP
Phone 1140E, see Headset “Headset support” (page 561).
Redeploying an IP Phone 1140E
You can redeploy an existing previously configured IP Phone 1140E on
the same Call Server. For example, the IP Phone 1140E can be assigned
to a new user (new TN) or to an existing user who moved to a new subnet
by changing the TN of the IP Phone 1140E. For further information, see
Converging the Data Network with VoIP Fundamentals (NN43001-260).
Procedure 88
Changing the TN of an existing IP Phone 1140E
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.06 30 April 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
.