User's Manual

332 Nortel IP Phone 1150E

• Procedure 93 “Changing the TN of an existing IP Phone 1150E” (page

353).

• Procedure 94 “Replacing an IP Phone 1150E” (page 354).

•

Procedure 95 “Removing an IP Phone 1150E from service” (page 354).

If power to the phone is interrupted after you install and configure an IP

phone, you are not required to reenter the IP Parameters, Node Numbers,

or Terminal Number (TN). There is also no need to again acquire the

firmware.

Description

The IP Phone 1150E uses the customer IP data network to communicate

with the Communication Server 1000 (CS 1000) . The IP Phone 1150E

translates voice into data packets for transport using Internet Protocol.

Use a Dynamic Host Configuration Protocol (DHCP) server to provide

information that you can use for the IP Phone 1150E network and CS 1000

connections.

The IP Phone 1150E is configured for either an Agent, or a Supervisor.

The IP Phone 1150E is shipped with Agent key configuration but can be

modified to support Supervisor key configuration by replacing the key

caps. Remove the key caps using the Key Cap removal tool (product

number NTNM19AA). For information about IP Phone 1150E components,

see “Package components” (page 344).

Figure 58 "IP Phone 1150E default Agent key configuration" (page

333) shows the IP Phone 1150E default Agent key configuration.

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.06 30 April 2010