User's Manual

ManualsBrandsAvaya ManualsIP DeskphonesAvaya Communication Server 1000 IP Phones Fundamentals

341

342

343

344

345

346

347

348

349

350

346 Nortel IP Phone 1150E

• If a global power supply is required, ensure the approved Nortel global

power supply (model number NTYS17xxE6) is used. See Table 80 "IP

Phone 1150E component list" (page 344).

•

Ensure the latest IP Phone firmware is deployed to the IP telephony

node. For more information, see Signaling Server IP Line Applications

Fundamentals (NN43001-125).

First-time installation

You must first install an IP telephony node with the Communication Server.

For information about installing an IP telephony node, see Signaling Server

IP Line Applications Fundamentals (NN43001-125).

CAUTION

Damage to Equipment

Do not plug your IP Phone 1150E into an ISDN connection.

Severe damage can result.

Conﬁguring the IP Phone 1150E

Use Procedure 91 “Configuring the IP Phone 1150E” (page 346) to

configure the IP Phone 1150E.

Procedure 91

Conﬁguring the IP Phone 1150E

Step Action

1 Configure a virtual loop on the Call Server using LD 97.

For more information about configuring a virtual loop, see

Signaling Server IP Line Applications Fundamentals (NN430

01-125) and Software Input Output Reference-Administration

(NN43001-611).

2 Configure the IP Phone 1150E on the Call Server using LD 11.

At the prompt, enter the following:

REQ: new

TYPE: 1150

For more information about configuring the IP Phone 1150E usi

ng LD 11, see Software Input Output Reference-Administration

(NN43001-611).

3 Configure the IP Phone 1150E in Element Manager. IP Phones

are configured using the Phones section in the Element

Manager navigation tree. For more information about configuring

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.06 30 April 2010