User's Manual

ManualsBrandsAvaya ManualsIP DeskphonesAvaya Communication Server 1000 IP Phones Fundamentals

351

352

353

354

355

356

357

358

359

360

Installation and configuration 351

CAUTION

Damage to Equipment

Do not plug any device into your IP Phone 1150E

Ethernet port other than an IEEE 802.3 Ethernet

network connection. The IP Phone 1150E does not

support multiple devices connected through the PC

Ethernet port.

7 Connect additional cables. If applicable, plug in optional USB

devices. Connect the Ethernet cable to the LAN Ethernet

connection. If you are using a global power supply, plug the

adapter into an AC outlet.

Complete steps 1 to 7, as needed, before wall-mounting the IP

Phone.

8 Wall-mount your phone (optional). Use Method A or Method B to

wall-mount the IP Phone. See Method A—using the mounting

holes on the bottom of the phone stand, or Method B—using the

traditional-style wall-mount box with a CAT5-e connector and a

15 cm (6 inch) CAT5-e cord (not provided).

• Method A: Press the wall-mount lever, and pull away from

the stand. Using the stand cover (see Figure 62 "Remove

the stand cover" (page 348)), mark the wall-mount holes

by pressing the bottom of the stand cover firmly against

the wall in the location where you wish to install the phone.

Four small pins on the bottom of the stand cover make the

marks on the wall. Use the marks as a guideline to install

the wall-mount screws (not provided). See Figure 64 "Cable

routing tracks" (page 350).

Install the screws so that they protrude 3 mm (1/8 inch) from

the wall, and then install the phone stand mounting holes

over the screw heads. You may need to remove the phone

from the wall to adjust the lower screws. When the lower

screws are snug, install the phone on the mounting screws,

and then tighten the top screws.

• Method B: Attach the 15 cm (6 inch) CAT5-e cable, position

the stand over the mounting rivets, and slide the phone down

the wall so that the rivets fit into the slots on the stand. See

Figure 64 "Cable routing tracks" (page 350).

9 Replace the stand cover. Ensure that all cables are neatly routed

and press the stand cover into place until you hear a click.

10 If you wall-mount the phone, put it in the wall-mount position by

holding the tilt lever and press the phone towards the base until

the phone is parallel with the base. Release the tilt lever and

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.06 30 April 2010