User's Manual

354 Nortel IP Phone 1150E

Replacing an IP Phone 1150E

ATTENTION

Two IP Phones cannot share the same TN. You must remove the IP Phone

1150E that currently uses the TN.

Procedure 94

Replacing an IP Phone 1150E

Step Action

1 Obtain the node and TN information of the phone you want to

replace.

2 Disconnect the IP Phone 1150E that you want to replace.

3 Follow “Configuring the IP Phone 1150E” (page 346) to install

the IP Phone 1150E. To configure the IP Phone, see “Manual

provisioning of IP Phones 2007 and 1100 Series” (page 541).

4 Enter the same TN and Node Number as the IP Phone 1150E

you replaced. The system associates the new IP Phone 1150E

with the existing TN.

--End--

Removing an IP Phone 1150E from service

Procedure 95

Removing an IP Phone 1150E from service

Step Action

1 Disconnect the IP Phone 1150E from the network or turn the

power off.

The service to the PC is disconnected as well if the PC connects

to the IP Phone 1150E.

If the IP Phone 1150E was automatically configured, the DHCP

lease expires and the IP address returns to the available pool.

2 In LD 11, enter the following:

REQ: OUT

TYPE: 1150

TN: LLL S CC UU

--End--

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.06 30 April 2010