User's Manual

Installation and configuration 365
Before you begin
Before installing the IP Phone 1165E, complete the following
pre-installation checklist
• Ensure one IP Phone 1165E boxed package exists for each IP Phone
1165E you install. For a list of IP Phone 1165E package components,
see Table 71 "Package components" (page 320).
•
Ensure one Software License exists for each IP Phone 1165E you
install.
• Ensure the host Call Server is equipped with a Voice Gateway Media
Card and a Signaling Server with the Line TPS application.
•
Ensure a LAN is properly configured and operational
•
If a global power supply is required, ensure the approved Nortel global
power supply (model number NTYS17xxE6) is used. See Table 86 "IP
Phone 1165E component list" (page 364).
•
Ensure the latest IP Phone firmware is deployed to the IP telephony
node. For more information, see Signaling Server IP Line Applications
Fundamentals (NN43001-125).
First-time installation
You must first install an IP telephony node with the Communication Server.
For information about installing an IP telephony node, see Signaling Server
IP Line Applications Fundamentals (NN43001-125).
CAUTION
Damage to Equipment
Do not plug your IP Phone 1165E into an ISDN connection.
Severe damage can result.
Configuring the IP Phone 1165E
Use the following procedure to configure the IP Phone 1165E.
Procedure 96
Configuring the IP Phone 1165E
Step Action
1 Configure a virtual loop on the Call Server using LD 97.
For more information about configuring a virtual loop, see
Signaling Server IP Line Applications Fundamentals (NN430
01-125) and Software Input Output Reference-Administration
(NN43001-611).
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.06 30 April 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
.