User's Manual

366 Nortel IP Phone 1165E

2 Configure the IP Phone 1165E on the Call Server using LD 11.

At the prompt, enter the following

REQ: new

TYPE: 1165

For more information about configuring the IP Phone 1165E usi

ng LD 11, see Software Input Output Reference-Administration

(NN43001-611).

3 Configure the IP Phone 1165E in Element Manager. IP Phones

are configured using the Phones section in the Element

Manager navigation tree. For more information about configuring

the IP Phone 1165E using Element Manager, see Element

Manager System Reference - Administration (NN43001-632).

For additional product and deployment information, including any

required Call Server patches, refer to the Partner Information

Center for any related Product Bulletins.

--End--

Connecting the components

Use the following procedure to connect the components for the IP Phone.

CAUTION

The IP Phone 1165E is shipped with the stand locked in the

wall-mount position. To avoid damaging the IP Phone, press the

wall-mount lever located under the Handsfree key to release the

stand and gently rotate it away from the IP phone.

Procedure 97

Connecting the components

Step Action

1 Press the wall-mount lever located under the Handsfree key to

release the stand and gently rotate it away from the IP phone.

See Figure 67 "Release the IP Phone 1165E from the stand"

(page 367).

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.06 30 April 2010