User's Manual

Installation and configuration 369

Figure 70

Cable routing tracks

5 Install the headset (optional). If you are installing a headset,

plug the connector into the RJ-9 headset jack on the back of the

phone, and thread the headset cord along with the handset cord

through the channels in the stand, so that the headset cord exits

the channel marked with the headset symbol. See <cable routing

tracks>.

6 Install the Ethernet cable. Connect one end of the supplied

Ethernet cable to the back of your phone using the CAT5-e

connector (LAN Ethernet port), and thread the network cable

through the channel.

7 Install the Ethernet cable connecting the PC to the phone

(optional). If you are connecting your PC through the phone, a

second CAT5-e cable is required. Only one cable is included

with the IP Phone 1165E package. Connect one end of the PC

Ethernet cable to your phone using the CAT5-e (PC Ethernet

port), and thread it through the channel marked with the symbol.

Connect the other end to the LAN connector on the back of your

PC.

The LAN Ethernet port supports Auto-Media Dependent Interface

Crossover (MDIX). Auto-MDIX is supported only when the

Ethernet port is configured for autonegotiation. The PC Port

does not support Auto-MDIX.

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.06 30 April 2010