User's Manual

Installation and configuration 37

The voltage rating of the global power supply must match the wall

outlet voltage. See Table 4 "IP Phone 2001 components list" (page

35).

• Ensure the latest IP Phone firmware is deployed to the IP telephony

node. For more information, see Signaling Server IP Line Applications

Fundamentals (NN43001-125).

First-time installation

You must first install an IP telephony node with the Communication Server.

For information about installing an IP telephony node, see Signaling Server

IP Line Applications Fundamentals (NN43001-125).

CAUTION

Do not plug your IP Phone 2001 into an ISDN connection.

Severe damage can result.

Conﬁguring the IP Phone 2001

Use Procedure 1 “Configuring the IP Phone 2001” (page 37) to configure

the IP Phone 2001 for the first time.

Procedure 1

Conﬁguring the IP Phone 2001

Step Action

1 Configure a virtual loop on the Call Server using LD 97. For

more information about configuring a virtual loop, see Signaling

Server IP Line Applications Fundamentals (NN43001-125) and

Software Input Output Reference-Administration (NN43001-611).

2 Configure the IP Phone 2001 on the Call Server using LD 11. At

the prompt, enter the following:

REQ:new

TYPE:2001P2

For more information about configuring the IP Phone 2001 using

LD 11, see Software Input Output Reference-Administration

(NN43001-611).

3 Configure the IP Phone 2001 in Element Manager. IP Phones

are configured using the Phones section in the Element

Manager navigation tree. For more information about configuring

the IP Phone 2001 using Element Manager, see Element

Manager System Reference - Administration (NN43001-632).

--End--

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.06 30 April 2010