User's Manual

ManualsBrandsAvaya ManualsIP DeskphonesAvaya Communication Server 1000 IP Phones Fundamentals

361

362

363

364

365

366

367

368

369

370

370 Nortel IP Phone 1165E

CAUTION

Damage to Equipment

Do not plug any device into your IP Phone 1165E

Ethernet port other than an IEEE 802.3 Ethernet

network connection. The IP Phone 1165E does not

support multiple devices connected through the PC

Ethernet port.

8 Connect additional cables. If applicable, plug in optional USB

devices. Connect the Ethernet cable to the LAN Ethernet

connection. If you are using a global power supply, plug the

adapter into an AC outlet.

Complete steps 1 to 8, as needed, before wall-mounting the IP

Phone.

9 Wall-mount your phone (optional). Use Method A or Method B to

wall-mount the IP Phone. See Method A—using the mounting

holes on the bottom of the phone stand, or Method B—using the

traditional-style wall-mount box with a CAT5-e connector and a

15 cm (6 inch) CAT5-e cord (not provided).

• Method A: Press the wall-mount lever, and pull away from

the stand. Using the stand cover (see step 2), mark the

wall-mount holes by pressing the bottom of the stand cover

firmly against the wall in the location where you wish to install

the phone. Four small pins on the bottom of the stand cover

make the marks on the wall. Use the marks as a guideline

to install the wall-mount screws (not provided). Due to the

wide variety of materials and construction techniques, the

user is advised to select an appropriate fastener or anchor

type for the wall. Consult your local hardware store or other

expert assistance in selecting the correct fastener for your

application."

Install the screws so that they protrude 3 mm (1/8 inch) from

the wall, and then install the phone stand mounting holes

over the screw heads. You may need to remove the phone

from the wall to adjust the lower screws. When the lower

screws are snug, install the phone on the mounting screws,

and then tighten the top screws.

• Method B: Attach the 15 cm (6 inch) CAT5-e cable (not

included), position the stand over the mounting rivets, and

slide the phone down the wall so that the rivets fit into the

slots on the stand.

10 Replace the stand cover. Ensure that all cables are neatly routed

and press the stand cover into place until you hear a click.

11 If you wall-mount the phone, put it in the wall-mount position by

holding the tilt lever and press the phone towards the base until

the phone is parallel with the base. Release the tilt lever and

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.06 30 April 2010