User's Manual

Installation 379

Installation

The Expansion Module mounts on the right side of the IP Phone. The

Expansion Module snaps into the receptacle on the back of the IP Phone

using the desk-mount bracket and structural baseplate supplied with the

Expansion Module.

The Expansion Module connects to the IP Phone using the Accessory

Expansion Module (AEM) port on the IP Phone.

Use Procedure 101 “Connecting the Expansion Module to the IP Phone”

(page 379) to connect the Expansion Module for IP Phones 1100 Series

to the IP Phone.

CAUTION

Damage to Equipment

To avoid damaging the equipment, remove the power (PoE

cable, or local power) from the IP Phone before connecting the

Expansion Module.

CAUTION

The Expansion Module is shipped with the base locked in

position. To avoid damaging the Expansion Module, press

the wall-mount lever, located on the base at the front of the

Expansion Module.

Procedure 101

Connecting the Expansion Module to the IP Phone

Step Action

1 Press the tilt lever to adjust the stand angle on the IP Phone.

See Figure 72 "Wall-mount lever" (page 380). You can adjust

the stand angle to maximum, instead of removing the stand. See

Figure 73 "Adjusting the stand angle on the IP Phone" (page

380).

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.06 30 April 2010