User's Manual

Removing an IP Phone 2001 from service 41

Replacing an IP Phone 2001

ATTENTION

Two IP Phones cannot share the same TN. You must remove the IP Phone

2001 that currently uses the TN.

Procedure 4

Replacing an IP Phone 2001

Step Action

1 Obtain the node and TN information of the phone you want to

replace.

2 Disconnect the IP Phone 2001 that you want to replace.

3 Follow “Configuring the IP Phone 2001” (page 37) to install the

IP Phone 2001. To configure the IP Phone, “Manual provisioning

of IP Phones 2000 Series” (page 551).

4 Enter the same TN and Node Number as the IP Phone 2001 you

replaced. The system associates the new IP Phone 2001 with

the existing TN.

--End--

Removing an IP Phone 2001 from service

Procedure 5

Removing an IP Phone 2001 from service

Step Action

1 Disconnect the IP Phone 2001 from the network or turn off the

power.

If the IP Phone 2001 was automatically configured, the DHCP

lease expires and the IP address returns to the available pool.

2 In LD 11, enter the following:

REQ: OUT

TYPE: 2001P2

TN: LLL S CC UU

--End--

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.06 30 April 2010