User's Manual

502 Provisioning the IP Phones
Procedure 120
Configuring parameters manually for text user interface
Step Action
1 Press Auto on the Configuration page to switch to the Auto
Provisioning page.
2 Perform one of the following actions:
•
Press the AllMan content-sensitive soft key on the Auto
Provisioning page to manually configure all parameters.
• Use the dial pad to enter the number associated with the
parameter, or use the navigation keys to scroll and highlight
the specific parameter. Then press Man to configure specific
parameters, which were previously configured automatically.
3 Press Enter to save the settings or press Cancel to exit the
Network Configuration without saving changes.
--End--
Configuration page for text user interface
Press Cfg on the Auto Provisioning page to access the Configuration
page.
For manual configuration steps, see “Manual provisioning of IP Phones
1110 and 1200 Series” (page 533).
If you configure parameters for automatic provisioning in the Auto
Provision page, the parameter appears dimmed in the Configuration page.
Automatic configuration
Provisioning information is stored on a managed central server. The IP
Phones can automatically obtain parameter values.
ATTENTION
The IP Phone receives provisioning information from a DHCP or TFTP server.
Some parameters require the IP Phone to reset in order for an updated value
to take effect.
Automatic provisioning parameters
Table 120 "Automatic provisioning parameters legend" (page
503) provides a legend for Table 121 "Provisioning parameters " (page
503).
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 05.06 30 April 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
.