User's Manual

ManualsBrandsAvaya ManualsIP DeskphonesAvaya Communication Server 1000 IP Phones Fundamentals

521

522

523

524

525

526

527

528

529

530

Automatic provisioning 527

REG= 00:1B:BA:F8:82:3D CS1K S1 7777 096-1-22-09;

reg= 00 1B BA F8 82 3E CS1K S1 7777 096-1-22-10;

reg= 001BbaF8823f Cs1k s1 8972 61 0;

reg= 00-1b-Ba-f8-82-4d cs1k S1 3434 96 00 01 11;

Automatic provisioning using UNIStim

You can use UNIStim to automatically provision a limited number of

parameters, such as Layer 2 priority bits (Ctrl and Media priority bits)

and Differentiated Service Code Point (DiffServ). For information about

configuring these parameters, see

Signaling Server IP Line Applications

Fundamentals (NN43001-125).

With UNIStim 3.1 and later, you can use Info Block to automatically

provision the following parameters on supported IP Phones:

• nis - network port speed

•

nid - network port duplex mode

•

dhcp - Dynamic Host Configuration Protocol (DHCP)

• ca - Certificate Authority (CA) server

•

cahost - CA host name

•

cadomain - CA domain name

For more information about these parameters, see Table 122 "Provisioning

info block format" (page 512).

CAUTION

Provisioning the network port speed or network port duplex

mode incorrectly, can cause loss of network connectivity. If this

occurs, you can only restore network connectivity by manually

provisioning the IP Phone.

CAUTION

Disabling DHCP incorrectly, can cause loss of network

connectivity. If this occurs, you can only restore network

connectivity by manually provisioning the IP Phone.

Provisioning Info Block

You can obtain configuration parameters in the IP Phone that are defined

as AUTO from the Auto Provisioning page from an 802.1ab switch (LLDP),

DHCP, TFTP, and UNIStim.

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.06 30 April 2010