User's Manual

Graphic-based diagnostics utilities 627

Figure 115

USB devices - lock pending

Figure 115 "USB devices - lock pending" (page 627) above shows an

1165E phone with a USB Flash Drive connected and enumerated. The

USB Headset and USB Flash Drive device types have been locked in the

USB Locks menu but the USB Headset lock is waiting on a reboot of the

phone for the lock to take effect. Once the phone is rebooted, the Warning

and "(pending reboot)" message will disappear and the USB Headset

device is just shown as locked.

6. Advanced Diag

The Advanced Diagnostics Tool allows you to configure the Secure Shell

(SSH) access of the IP Phone, and control the auto recovery events. The

Advanced Diag Tools sub menu displays the following items:

• Auto Recovery: This check box controls whether the phone

auto-recovers (reboots) when a problem exceeds the pre-defined fault

level occurs. The default setting is checked.

• Enable SSH: This check box enables SSH access for the phone.

When selected, the phone allows a remote host to connect using the

SSH protocol. The default setting is unchecked.

• User ID: This is the user ID that must be used by a SSH session when

establishing a connection to the phone. This option is available only

if Enable SSH is selected.

• Password: This is the password that must be used by a SSH session

when establishing a connection to the phone. This option is available

only if Enable SSH is selected.

7. DHCP Information

Use the DHCP Information menu option to display Nortel DHCP option

strings on your phone. If DHCP is enabled the DHCP Information screen

displays the "Nortel-i2004-A", the "Nortel-i2004-B", and the "VLAN-A"

option strings received by the phone from the DHCP server. If no option

Nortel Communication Server 1000

IP Phones Fundamentals

NN43001-368 05.06 30 April 2010